ProSeal & ProDry w/ Leak Detector for 134 Systems 3 oz Can/Cases

SDS

 Proseal Prodry with Leak Detector SDS (230 KB, PDF)

• Aerosol
• ProSeal (sealant) & ProDry (moisture eliminator) with Leak Detector (dye) is perfect for finding and sealing those pesky leaks, and with the added Prodry, it will turn that moisture into oil!  Prodry features a dehydrating agent that converts system moisture into a synthetic oil to stop and prevent acid formation in your system while also increasing cooling performance.
• Forms a hard seal on metal, schrader valves, o’rings, gaskets, a/c condensers, evaporators, line sets and solder joints
• Even though Proseal with Leak Detector can form a seal on the schrader valve, when you hook up to it the seal will release and allow you to use the schrader if necessary. If there is still Proseal with Leak Detector in the system it will reseal the schrader.
• While the dye is highly visible, and in most cases, able to be seen with the naked eye, the use of a blacklight as well as UV glasses does make it much more visible.
• 1 can of Enviro-Safe ProSeal ProDry with Dye will treat one vehicle.
• Works on most mobile applications.
• Applications: automotive, campers, semi-tractor trailers, combines, thrashers, agriculture applications.
• DO NOT use in ammonia systems
• DO NOT use in CO2 systems
• DO NOT use in R410a systems- Pressure is too high and will explode the can
• Cannot be sent to Alaska or Hawaii or exported to foreign countries except in pallet quantities
• Gas propelled
• Installs the same way as refrigerant
• Cannot be added to a fully charged system

DIRECTIONS FOR USE:

Make sure system is off before connecting to the system. WARNING! CONTENTS UNDER PRESSURE ALL LABELED HAZARDOUS PRECAUTIONS MUST BE OBSERVED.

As per use with any flammable substance, take adequate precautions during use. 
1. Shake can well. 
2. Install can tap valve and charging hose. 
3. Install charging hose on low pressure side. 
4. Turn A/C on. 
5. Invert can. 
6. Install all product from can. 
7. Fill system to correct pressure. 
8. DO NOT overcharge the a/c system. 
9. Run the system thirty (30) minutes at a minimum to circulate the product. 
10. Dispose of container according to local/state/national/international standards. 
This can will treat up to a four (4lb) system.

Note: This product will repair most small leaks in evaporators, condensers, o'rings, and schraders.