ProSeal w/Leak Detector for R1234YF w/ Brass R1234YF Hose #4840
SDS
1234 Proseal with Leak Detector SDS (246 KB, PDF)
ProSeal with Leak Detector R1234YF is perfect for finding and sealing those pesky leaks!
Includes:
- 1 can of Enviro-Safe 1234YF ProSeal with Leak Detector
- 1 hose with R134a top tap and R1234YF vehicle end.
- Aerosol
- Finds and seals leaks in ac systems
- 1 can of Enviro-Safe 1234YF ProSeal with Leak Detector will treat 1 vehicle.
- Forms a hard seal on metal, schrader valves, o’rings, gaskets, a/c condensers, evaporators, line sets and solder joints
- Even though Proseal with Leak Detector for R1234YF can form a seal on the schrader valve, when you hook up to it the seal will release and allow you to use the schrader if necessary. If there is still Proseal with Leak Detector for R1234YF in the system it will reseal the schrader.
- Proseal with Leak Detector for R1234YF uses a precisely selected, fluorescent-yellow dye that is highly visible and is the same dye used by auto makers in car A/Cs
- While the dye is highly visible, and in most cases, able to be seen with the naked eye, the use of a blacklight as well as UV glasses does make it much more visible.
- Before replacing expensive parts and labor, try Enviro-Safe Proseal with Leak Detector!
- For best results, use Enviro-Safe Prodry for R1234YF BEFORE using the Enviro-Safe Proseal with Leak Detector for R1234YF to remove any moisture in your system. Moisture is corrosive and no one wants that in their system!
- DO NOT use in ammonia systems
- DO NOT use in CO2 systems
- DO NOT use in R410a systems- Pressure is too high and will explode the can
- Cannot be sent to Alaska or Hawaii or exported to foreign countries except in pallet quantities
- Gas propelled
- Installs the same way as refrigerant
- Cannot be added to a fully charged system
Directions for Use:
Check system pressure and make sure system is charged properly before installing product. Make sure system is off before connecting to the system. WARNING! CONTENTS UNDER PRESSURE ALL LABELED HAZARDOUS PRECAUTIONS MUST BE OBSERVED. As per use with any flammable substance, take adequate precautions during use. Before using this product, it is recommended to use Enviro-Safe ProDry in the system.
Check system pressure and make sure system is charged properly before installing product. Make sure system is off before connecting to the system. WARNING! CONTENTS UNDER PRESSURE ALL LABELED HAZARDOUS PRECAUTIONS MUST BE OBSERVED. As per use with any flammable substance, take adequate precautions during use. Before using this product, it is recommended to use Enviro-Safe ProDry in the system.
1. Shake can well.
2. Install can tap valve and charging hose.
3. Install charging hose on low pressure side.
4. Turn A/C on.
5. Invert can.
6. Install all ProSeal from can.
7. Fill system to correct pressure.
8. DO NOT overcharge the a/c system.
9. Run the system thirty (30) minutes at a minimum to circulate the ProSeal.
10. Dispose of container according to local/state/national/international standards.
This can will treat up to a four (4lb) system.
Note: This product will repair most small leaks in evaporators, condensers, and fittings.