ProSeal w/Dye Direct Inject #2250AI

SDS

 Proseal with Dye Direct Inject SDS (216 KB, PDF)

Please note that any 0-5 ton injects marked with "Free Shipping" will ship via USPS unless purchased with something that must ship via Fedex/UPS. 

One of our most requested products, Enviro-Safe® ProSeal XL4 Inject with Dye is a small, concentrated, easy inject refrigerant leak sealant.  ProSeal XL4 Inject is compatible with all refrigerants except ammonia. This product performs best in heat pumps, split and mini- split units, packaged units, microchannel coils, coolers, and commercial units.

Enviro-Safe™ has been producing and packaging sealants for over 17 years. Our Sealant Injector hose was designed and tested during 2013/2014 and has been produced and marketed under private label since the fall of 2014.

• This item is available by the box, 3 pack and 8 pack.
• Finds and seals leaks in ac systems
• Unlike most other products on the market, ProSeal XL4 with Dye Inject travels with the gas, which makes it faster, and more effective at finding leaks. ProSeal XL4 with Dye Inject will seal most leaks when used according to the manufacturer’s instructions and will seal most small holes located in the A/C condenser, evaporator, fittings, and metal line sets. Sealing leaks will save energy and lower refrigerant emissions.
• Forms a hard seal on metal, schrader valves, o’rings, gaskets, a/c condensers, evaporators, line sets and solder joints
• Even though ProSeal XL4 with Dye can form a seal on the schrader valve, when you hook up to it the seal will release and allow you to use the schrader if necessary. If there is still ProSeal XL4 with Dye in the system it will reseal the schrader.
• ProSeal XL4 with Dye uses a precisely selected, florescent-yellow dye that is highly visible and is the same dye used by auto makers in car A/Cs
• This product performs best in heat pumps, split and mini- split units, packaged units, microchannel coils, coolers, and commercial units.
• Applications: heat pumps, split systems & mini split units, packaged units, and microchannel coils
• DO NOT use in ammonia systems
• One-time use
• Concentrated
• No need to pump-down R410 or other units
• No injection-hose or caulk-gun needed
• Concentrated formula means less material in the system

Professional Use Only

Instructions for use:

Step 1: Turn the a/c system on, and verify the unit is running. Connect Direct Inject to the low side service port of the system. (This is generally the large line.) 

Step 2: Connect the manifold refrigerant hose to the refrigerant supply tank. Verify the manifold high & low side valves on the manifold are closed before proceeding. Purge the air from the low side.

Step 3: Open low side valve, watch for the tube to clear. (This will ONLY take a few seconds!) Turn off low side manifold valve as soon as the tube is clear. Turn off refrigerant gas. Verify the system is charged to manufacturer’s specifications. Disconnect low side hose from ProSeal XL4 Inject. Install service port cap. Run the a/c unit at least one hour after installing Direct Inject.

Note: Do Not use Enviro-Safe Direct Inject in any manner it was not designed!